1/4-Inch Device Removal - NEC POWERMATE P - SERVICE MANUAL 1996 Service And Reference Manual

5-12 Repair
Figure Section 5-13 Diskette Drive Bracket Screws
Slide the 3 1/2-inch diskette drive out of the slot in the front of the chassis.
4.

5 1/4-Inch Device Removal

Remove a 5 1/4-inch device (CD-ROM reader or other device) from the 5 1/4-inch device
cage as follows.
1. Remove the system unit cover and front panel as previously described.
2. Disconnect the device signal and power cables from the inside of the system unit.
(If removing a CD-ROM reader, also disconnect the audio cable.)
Remove the device as follows:
3.
n
If removing the device from the top 5 1/4-inch slot, remove the four screws,
two to a side, that secure the device in the cage (see Figure Section 5-14 and
Figure Section 5-15).
n
If removing a device from the middle or bottom 5 1/4-inch slot, remove the
two screws that secure the device in the cage (see Figure Section 5-14).
n
Slide the device out from the front of the system unit.
NOTE: The 5 1/4-inch devices are installed with
drive rails.