Table of Contents
Advertisement
Blank Panel and Metal Cover Plate Removal
Remove the blank panels and the metal cover plates from the chassis as follows.
1.
Remove the blank panel from the selected slot by pressing the panel tabs from
inside the front panel and pushing the blank panel out (see Figure Section 5-7).
Store the blank panel for possible later reinstallation.
Press in on the tab and remove the metal slot cover from the selected slot on the
2.
front of the system.
Figure Section 5-7 Locating the Blank Panel Tabs
3.
Remove the slot cover from the selected slot on the front of the system chassis
(see Figure Section 5-8). On some units, the slot covers may be held in place with
screws; other units may have metal tabs holding the slot covers in place.
Repair
5-7
Advertisement
Table of Contents
Troubleshooting
