Aiwa HV-MX100U Operating Instructions Manual page 17

1
2
ZERO
RETURN _
o
s
OOOH
000
0
0000
00
0
0-
0
0
&
0
,-
?
q.
000 0
n
00
00
v
SEARCHIINDEX
–m a
— STOP m
RESET
o
_
DISPLAY
o
F
lPress II PAUSE/STILL to pause the picture.
Spin the jog dial right (or left for reverse
Iplayback) with your finger.
"The playback speed varies according to the speed you
spin the jog dial.
If you continue slow motion playback for more than 5
minutes, the VCR will automatically enter stop mode to
protect the tape.
The sound will be muted during various speed playback.
With tapes recorded in PAL, SECAM, MESECAM or N-PAL
color systems at LP speed, the color fades during slow
motion playback or high speed playback,
~ Press COUNTER RESET at the point you want
to locate later.
The tape counter in the display window resets to
"0:00:00."
n.nll. nl-i
LI" LILI'LIU
z After playback or recording, press ti STOP,
then ZERO RETURN.
The tape automatically stops when the tape counter
returns to about "0:00 :00."
To cancel Zero
Press H STOP.
4&s
Return
@You can also see the tape counter on the screen display.
Press COUNTER DISPLAY repeatedly until the tape counter
appears. (See page 24.)
QTo play, eject and switch off automatically after tape counter
returns to about "0:00:00." press ZERO RETURN then press
- PLAY, 4 EJECT or POWER within 2 seconds.
When you insert a cassette, the tape counter is reset to
"0:00:00."
The tape counter does not work while playing unrecorded
portions of tape.
The VCR automatically marks an index signal on the tape
each time recording starts. "INDEX flashes on the TV
screen while the VCR marks an index signal. You can use
these signals to find the beginning of any recording.
Press > SEARCH/lNDEX (for succeeding
programs) or <+ SEARCH/lNDEX (for preceding
programs) repeatedly during stop until the index
number (up to 20) you want appears on the TV
screen.
The VCR starts searching.
When the VCR detects the index number, playback starts
automatically from the beginning of the specified recording.
Index number
You can also use the display window to check the index number
you specified. "INDEX and the index number will appear in the
display window when you press <~/P> SEARCH/lNDEX.
Index signals should be at least 1 minute apart in SP
mode,
2 minutes apart in
LP
mode, and 3 minutes apart in EP
mode. Otherwise, the VCR cannot detect them properly.
Index signals may not be detected on damaged or worn out
tapes.
Index signals may not be detected at the beginning of
recordings where the tape speed is different from the
previous program.
The index signal at the beginning of a recorded tape may not
be detected.
The index search indicator and index number do not appear
if the display mode is off.
ENGLISH 16