Show Snmp Filter - SMC Networks E21011 User Manual

This command displays the SNMP v3 notification filter settings.

show snmp filter

S
YNTAX
C
OMMAND
Exec
E
XAMPLE
AP# show snmp filter
Filter List:
==================================
Filter: defaultfilter
Filter: testfilter
==================================
AP#
This command displays the SNMP configuration settings.
show snmp
C
OMMAND
Exec
E
XAMPLE
AP# show snmp
SNMP Information
==============================================
Service State
Community (ro)
Community (rw)
Location
Contact
==============================================
Trap Destination List:
==============================================
Trap Destination: 192.168.1.22,
==============================================
Trap Configuration:
==========================================================================
show snmp filter [filter-id]
filter-id - A user-defined name that identifies an SNMP v3
notification filter. (Maximum length: 32 characters)
M
ODE
Type: Included
Subtree: .1
Type: Excluded
Subtree: .1.3.6.1.2.1.2.2.1.1.23
Type: Excluded
Subtree: .13.6.1.2.1.2.2.1.2
M
ODE
– 159 –
C
HAPTER
: Enable
: *******
: ********
: where?
: who?
Community : *****
| SNMP Commands
17