SMC Networks E21011 User Manual page 157

◆
E
This command configures SNMP v3 notification filters. Use the no form to
snmp-server filter
delete an SNMP v3 filter or remove a subtree from a filter.
S
D
None
C
Global Configuration
C
◆
◆
◆
E
The SNMP v3 user name that is specified in the target must first be
configured using the snmp-server user command.
XAMPLE
AP(config)#snmp-server target tarname 192.168.1.33 chris 1234
AP(config)#
YNTAX
snmp-server filter <filter-id> <include | exclude> <subtree>
no snmp-server filter <filter-id> [subtree]
filter-id - A user-defined name that identifies an SNMP v3
notification filter. (Maximum length: 32 characters)
include - Defines a filter type that includes objects in the MIB
subtree.
exclude - Defines a filter type that excludes objects in the MIB
subtree.
subtree - The part of the MIB subtree that is to be filtered.
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
The access point allows multiple notification filters to be created. Each
filter can be defined by up to 20 MIB subtree ID entries.
Use the command more than once with the same filter ID to build a
filter that includes or excludes multiple MIB objects. Note that the filter
entries are applied in the sequence that they are defined.
The MIB subtree must be defined in the form ".1.3.6.1" and always
start with a ".".
XAMPLE
AP(config)#snmp-server filter trapfilter include .1
AP(config)#snmp-server filter trapfilter exclude .1.3.6.1.2.1.2.2.1.1.23
– 157 –
| SNMP Commands
C 17
HAPTER