SMC Networks E21011 User Manual page 187

vap (STP Interface)
path-cost (STP
Interface)
C U
OMMAND SAGE
◆ This command defines the priority for the use of a port in the Spanning
Tree Protocol. If the path cost for all ports on a wireless bridge are the
same, the port with the highest priority (that is, lowest value) will be
configured as an active link in the spanning tree.
◆ Where more than one port is assigned the highest priority, the port with
lowest numeric identifier will be enabled.
E
XAMPLE
AP(if-wireless a)#bridge-link port-priority 1 64
AP(if-wireless a)#
R C
ELATED OMMANDS
bridge-link path-cost
This command selects the VAP interface for configuring STP settings.
S
YNTAX
vap <vap-index>
vap-index - The index number for the VAP interface. (Range: 0-7)
C M
OMMAND ODE
Global Configuration (STP interface)
E
XAMPLE
AP(stp-if-wireless 0)# vap 0
AP(stp-if-wireless 0: VAP[0])#
This command sets the spanning tree path cost for the VAP interface.
S
YNTAX
path-cost <cost>
cost - The path cost for the VAP interface. (Range: 1-65535)
C M
OMMAND ODE
Global Configuration (STP interface)
C U
OMMAND SAGE
This command is used by the Spanning Tree Protocol to determine the
◆
best path between devices. Therefore, lower values should be assigned
to interfaces with faster media, and higher values assigned to
interfaces with slower media.
Path cost takes precedence over port priority.
◆
– 187 –
| Spanning Tree Commands
C 23
HAPTER