| Introduction
C
1
HAPTER
Hardware Description
LED I
NDICATORS
The access point includes four status LED indicators, as described in the
following figure and table.
Figure 6: LEDs
Ethernet
802.11 a/b/g/n
Link/Activity
Link/Activity
Table 2: LED Behavior
LED
Status
LAN
Off
Blue
Green
Amber
WLAN
Off
Green
Yellow
Diag/Fail
Off
Red
Blinking
Power
Off
Yellow
– 32 –
System Error
or Failure
Description
Ethernet RJ-45 has no valid link.
Ethernet RJ-45 has a 1000 Mbps link.
network activity.
Ethernet RJ-45 has a 100 Mbps link.
network activity.
Ethernet RJ-45 has a 10 Mbps link.
network activity.
The AP radio is disabled.
The radio is operating at 5 GHz (802.11a/n). Blinking
indicates network activity.
The radio is operating at 2.4 GHz (802.11b/g/n). Blinking
indicates network activity.
The AP is operating normally.
The AP has detected a fault.
The system is initializing.
The AP has no power.
The AP is receiving power.
Power
Blinking indicates
Blinking indicates
Blinking indicates