7
Command Line Interface
Ethernet Interface Commands
The commands described in this section configure connection parameters for the
Ethernet port and wireless interface.
Command
interface ethernet
dns primary- server
dns secondary- server
ip address
ip dhcp
speed-duplex
shutdown
show interface ethernet
interface ethernet
This command enters Ethernet interface configuration mode.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 10/100Base-TX network interface, enter the following command:
Enterprise AP(config)#interface ethernet
Enterprise AP(if-ethernet)#
7-88
Table 7-16. Ethernet Interface Commands
Function
Enters Ethernet interface configuration mode
Specifies the primary name server
Specifies the secondary name server
Sets the IP address for the Ethernet interface
Submits a DHCP request for an IP address
Configures speed and duplex operation on the
Ethernet interface
Disables the Ethernet interface
Shows the status for the Ethernet interface
Mode
Page
GC
7-89
IC-E
7-90
IC-E
7-90
IC-E
7-90
IC-E
7-91
IC-E
7-92
IC-E
7-93
Exec
7-93