Figure 3-46. Enabling Port Broadcast Control - SMC Networks 8748L2 Management Manual

C
ONFIGURING THE
Web – Click Port, Port Broadcast Control. Set the threshold any port, click
Apply.
CLI – Specify any interface, and then enter the threshold. The following
disables broadcast storm control for port 1, and then sets broadcast
suppression at 500 packets per second for port 2.
Console(config)#interface ethernet 1/1
Console(config-if)#no switchport broadcast
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast packet-rate 500
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2
Information of Eth 1/2
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,1000M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan:
Forbidden Vlan:
Console#
3-98
S
WITCH

Figure 3-46. Enabling Port Broadcast Control

1(u),
4-132
4-138
4-138
4-143