Showing Port Statistics; Figure 3-48. Configuring Input Port Rate Limiting - SMC Networks 8748L2 Management Manual

Command Usage
• Input rate limit can be enabled or disabled for individual interfaces.
Command Attribute
• Port/Trunk – Display the port number.
• Rate Limit Status– Enables or disables the rate limit (Default: Enabled)
• Rate Limit Level - Sets the rate limit level.
Web - Click Port, Rate Limit, Input Port/Trunk Configuration. Enable the
Rate Limit Status for the required interfaces, set the Rate Limit Level, and
click Apply.
CLI - This example sets the rate limit for input traffic passing through
port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#rate-limit input 25
Console(config-if)#

Showing Port Statistics

You can display standard statistics on network traffic from the Interfaces
Group and Ethernet-like MIBs, as well as a detailed breakdown of traffic
based on the RMON MIB. Interfaces and Ethernet-like statistics display
errors on the traffic passing through each port. This information can be

Figure 3-48. Configuring Input Port Rate Limiting

P C
ORT ONFIGURATION
4-132
4-147
3-101