Servotronix CD3E Quick Start Manual page 7

CD3E
2 Safety
2.1 Safety Symbols
Safety symbols indicate a potential for personal injury or equipment damage if the
prescribed precautions and safe operating practices are not followed.
The following safety-alert symbols are used on the drive and in the documentation.
Symbol Meaning
Caution
Dangerous
voltage
Protective earth;
protective ground
Caution, hot
surface
2.2 Safety Guidelines
Only qualified personnel may perform installation, operation, service and maintenance
procedures. These persons must have sufficient technical training and knowledge to foresee
and recognize potential hazards that may occur when using the product, modifying settings,
and operating the mechanical, electrical and electronic components of the entire machine
system.
All persons working on and with the product must be fully familiar with all applicable
⚫
standards, directives, and accident prevention regulations when performing such work.
The CD3E servo drive is intended for use as a component within a machine system.
⚫
The machine builder and integrator must ensure the protection of both personnel and
⚫
the complete machine system.
The machine builder and/or integrator must perform a risk assessment in view of using
⚫
the CD3E drive in the intended application. Based on the results, the appropriate safety
measures must be implemented.
The CD3E drive must be used in compliance with all applicable safety regulations and
⚫
directives, and all technical specifications and requirements.
Before installing the CD3E, be sure to review the safety instructions in the product
⚫
documentation. Failure to follow the safety instructions may result in personal injury or
equipment damage.
Quick Start Guide
错误!使用"开始"选项卡将 Heading 1 应用于要在此处显示的文字。
Description
Indicates caution is necessary when operating the
device. Also indicates the current situation needs
operator awareness or operator action to avoid
undesirable consequences.
Indicates hazards arising from dangerous voltages. 5036
Identifies any terminal which is intended for
connection to an external conductor for protection
against electric shock in case of a fault, or the
terminal of a protective earth (ground) electrode.
Indicates the marked item can be hot and should
not be touched without taking care.
ISO 7000/
IEC 60417
0434
5019
5041
7