DiGidot C4 Manual page 45

Fading yellow-off
Blinking red for 1 second Error
Alternating red
Alternating blue-red
Alternating red-yellow
Alternating red-white
Battery Error: Both top- and side status lights alternating from yellow to red for 3 sec-
onds. (Contact DiGidot for further instructions.)
Network status lights
Ethernet left LED (orange or green) - Link established
Ethernet right LED (blinking green) - Data transfer active
Please note that, in case the status lights are not lighting up when the device is pow-
ered and connected to a network, the status lights may be switched off in the user
interface.
Open the user interface
No output signal from DiGidot C4
Make sure that:
the DiGidot C4 is powered.
master brightness, port limiters are not set to zero.
the HSV filter is not set to black.
the inputs and outputs are configured.
the scene is compatible with the outputs.
In case your data cable between the DiGidot C4 and your first LED/IC is longer
than 2 meters (6.5 ft), please reduce this length to an absolute minimum and
check if this solves the problem. If the controller(s) now output correctly, the
data cable runs were too long for your setup.
C4 Manual
G d ot
Informative
Error
Error
Error
Error
Error
Settings Device to check and switch them back on again.
Version 1.0
The DiGidot C4 is preparing for a
factory reset, keep the button
pressed until the fading stops
Failed saving settings or an error has
been encountered.
No valid license found
The microSD card must be formatted
The DiGidot C4 system has been
frozen, a reset will be performed
The internal battery is empty or has a
problem
The DiGidot C4 has crashed, a reset
will be performed
45