Selecting The Sequencer Data That Will Be Recorded (Recording Select) - Roland Fantom G8 User Manual

Recording MIDI
Grid Resolution
Make this setting when you are using Grid Quantize. Specify
the quantization interval in terms of a note value. Select the
shortest note value that will occur in the range to which Grid
Quantize will be applied.
Value: , , ,
Grid Quantize Strength
Make this setting when you are using Grid Quantize. It specifies
the degree to which notes will be adjusted toward the timing
intervals specified by the Grid Resolution parameter. With a
setting of "100%," the notes will be corrected precisely to the
timing of the Grid Resolution parameter. As you lower this
setting, the note timing will be corrected to a lesser extent, and
with a setting of "0%" the timing will not be adjusted at all.
Value: 0–100%
Shuffle Resolution
When you are using Shuffle Quantize, make this setting to
specify the note value used for quantization.
Value: ,
Shuffle Rate
Make this setting when using Shuffle Quantize. It specifies the
degree to which the backbeat will be separated from the
downbeat specified by the Shuffle Resolution parameter. With a
setting of "50%," the backbeat will be exactly between adjacent
downbeats. With a setting of "0%," the backbeat will be moved
to the same timing as the preceding downbeat. With a setting of
"100%," the backbeat will be moved to the same timing as the
following downbeat.
Value: 0–100%
224
, , ,
Selecting the Sequencer Data that
will Be Recorded (Recording Select)
When you use realtime recording, all of your sequencer data will
normally be recorded. If you want to avoid recording a specific type
of data, you can turn its Recording Select setting "OFF."
1.
Press [REC].
2.
Press [F7 (Rec Select)].
The Recording Select window appears.
3.
Use or to select the sequencer data (MIDI
messages) that will be recorded.
Note: Note messages. These MIDI messages
represent notes.
Poly Aftertouch: Polyphonic aftertouch. These MIDI
messages apply aftertouch to individual
keys.
Control Change: Control change messages. These MIDI
messages apply various effects such as
modulation or expression.
Program Change: Program change messages. These MIDI
messages select sounds.
Channel Aftertouch: Channel aftertouch messages. These
MIDI messages apply aftertouch to an
entire MIDI channel.
Pitch bend messages. These MIDI
Pitch Bend:
messages change the pitch.
System Exclusive: System exclusive messages. These MIDI
messages are used to make settings
unique to the Fantom-G, such as sound
parameters.
4.
Turn the VALUE dial or press [INC] [DEC] to add a check
mark.
The message will be recorded if you assign a check mark (✔),
and will not be recorded if you remove the check mark.
If you press [F6 (All Off)], no sequencer data will be recorded.
If you press [F7 (All On)], all of the sequencer data will be
recorded.
5.
Press [F8 (Close)] to close the Recording Select window.