Adjusting How The Instrument Responds; Adjusting The Volume Of The Vintage Organ (Vintageorganvolume); Selecting The Parts To Which Vibrato Or Chorus Will Be Applied (Vibrato/Chorus Part); Adjusting The Initial Touch Sensitivity (Initial Touch) - Roland MUSIC ATELIER Series Owner's Manual

Adjusting How the Instrument
Responds
Adjusting the Volume of the Vintage Organ
(VintageOrganVolume)
You can adjust the volume of the Vintage Organ sound to regulate the
volume balance relative to the other sounds.
Value
0–12
Selecting the Parts to which Vibrato or
Chorus will be Applied (Vibrato/Chorus Part)
For the vintage organ voices, you can choose the parts to which the
vibrato or chorus effect (p. 34) will be applied.
Value
UPPER+LOWER
UPPER
LOWER
Adjusting the Initial Touch Sensitivity
(Initial Touch)
This adjusts the amount of the Initial Touch effect applied.
Initial Touch is a function that translates the force used in playing the
keys into a directly proportional amount of volume.
This can be set separately for both the upper keyboard and lower
keyboard.
Parameter Value
1–10
Upper, Lower
OFF
92
Explanation
Increasing the value will increase the volume of
the Vintage Organ sound.
Explanation
The effect will be applied to the upper keyboard
part and the lower keyboard part.
The effect will be applied to the upper keyboard
part.
The effect will be applied to the lower keyboard
part.
Explanation
Initial Touch is ON.
Striking the keys more forcefully will
produce correspondingly louder sounds.
The change in volume when the keys are
played forcefully increases as the value
is increased.
Initial Touch is off.
Volume remains constant regardless of
how hard you play.

Turning Initial Touch Off (EZ Touch)

This allows you to perform at a consistent volume regardless of how
strongly you play the keyboard.
Value
OFF
ON
You can also use the following procedure to turn the EZ Touch function
on.
1. Hold down the [Reset] button and press the Pedal [To Lower]
button.
A message letting you know that the EZ Touch function has been
turned on will be displayed for a few seconds.
2. To turn off the EZ Touch function, hold down the [Reset]
button once again and press the Pedal [To Lower] button.
Changing How the Solo Voice Responds
(Solo Mode)
When the Solo voice is assigned to the Upper keyboard or Lower
keyboard, you can specify how the Solo voice will respond when more
than one key is pressed.
Value
TOP NOTE
LAST NOTE
POLYPHONIC
Layering the Solo Voice and Lower Voice
(SoloToLower Mode)
When the Solo voice is being played by the Lower keyboard (i.e., when
the Solo [To Lower] button is ON), you can specify whether the Lower
voice and the Solo voice will sound together (layered), or will sound
separately (split).
Value
SPLIT
LAYER
Explanation
Initial touch will be on.
The volume will remain constant regardless of
the force you use when playing the keyboard.
Initial touch will be off.
Explanation
The Solo voice will sound the highest note that
is played for the Solo part.
The Solo voice will sound the note that was
most recently played for the Solo part.
The Solo voice will sound all notes that are
played for the Solo part.
Explanation
The parts will sound separately.
The Lower voice and Solo voice will sound
together.