Shifting Performance Data Forward And Back (Shift Clock) - Roland Fantom G8 User Manual

Editing Songs
Shifting Performance Data
Forward and Back (Shift Clock)
This function shifts the timing of sequencer data backward or
forward in time within a specified area in steps of 1 tick. Slight shifts
of timing can speed up or drag performance.
When this function is executed, data that would be moved to a
point before the beginning of the phrase will automatically shift
to the beginning of the phrase. If data would be moved to a
point past the end of the phrase, additional new measures will
be created automatically as needed. The time signature of the
newly created measures will be the same as that of the measure
immediately preceding.
For details on the settings, refer to "Phrase Modify Menu" (p.
239)
Part Group
Specifies the Part Group.
Value
Internal
EXP1
EXP2
External
ALL
Ch (MIDI Channel)
Selects the MIDI channel of the data to be shifted in time.
To shift ticks of all sequencer data, set this parameter to "ALL." To
shift the sequencer data tick of just one specific MIDI channel, select
that MIDI channel.
Value: ALL, Ch1–Ch16
Measure, For (Edit Range)
Specifies the range of measures in which the sequencer data will be
moved in units of one tick. If you set "For" to "ALL," all measures
will be specified.
Bias
Specify the amount (number of ticks) by which the sequencer data
will be moved.
Value: -4800– +4800
248
Explanation
Internal (internal sound generator)
Expansion board 1
Expansion board 2
External MIDI output
All part group
Status
Selects the type of data to be shifted in time.
Value
ALL
NOTE
Poly Aftertouch
Control Change
Program Change
Channel Aftertouch
Pitch Bend
System Exclusive
Tune Request
Range Min, Range Max
If you set the Status parameter to "NOTE," "P.AFT," "C.C," or
"PROG," specify the range of data. Set "Range Min" to the lowest
value of the range, and "Range Max" to the highest value of the
range.
To shift all notes or polyphonic aftertouch data, set "Range
Min" to "C -1" and "Range Max" to "G9." To shift C4, set
"Range Min" and "Range Max" to "C4." To shift C3 through
C4, set "Range Min" to "C3" and "Range Max" to "C4."
• To shift all controller numbers, set "Range Min" to "0" and
"Range Max" to "127." To shift all program numbers, set
"Range Min" to "1" and "Range Max" to "128." To shift number
4, set "Range Min" and "Range Max" to "4." To shift numbers 3
through 14, set "Range Min" to "3" and "Range Max" to "14."