Signal Flow Diagram And Parameters - Roland Fantom G8 User Manual

Adding Effects

Signal Flow Diagram and Parameters

fig.22-005
6
8
11
5
2 7
1
9
3
10
4
In Single mode and Live mode, MFX 1 (multi-effect) will apply
only to the external input or to audio tracks, and therefore is
now shown in the internal routing diagram.
Tone Select
1
Select the tone for which you want to make settings.
Value: ALL, 1–4
This parameter is Rhythm Key Select when a rhythm set is
being selected. You can select the rhythm tone (A0–C8) for
which you want to make settings.
Tone Output Level
2
Set the level of the signal that is sent to the output destination
specified by Output Assign.
Value: 0–127
Tone Chorus Send Level
3
Sets the level of the signal sent to chorus for each tone.
Value: 0–127
Tone Reverb Send Level
4
Sets the level of the signal sent to reverb for each tone.
Value: 0–127
Tone Output Assign
5
Specifies how the direct sound of each tone will be output.
Value:
PFX: Output through patch multi-effects (PFX).
DRY: Output without passing through patch multi-effects
(PFX).
PFX Sw
1 6
Switches the patch multi-effect on/off.
Value: ON, OFF
152
13
16
12
19 20 21
14
17
18
15 24 25
22
23
PFX Type (Patch Multi-Effects Type)
7
Use this parameter to select from among the 76 available patch
multi-effects. For details on patch multi-effects parameters, refer
to "MFX/PFX Parameter" (p. 161).
Value: 0 (Through)–76
PFX Output Level
8
(Patch Multi-Effects Output Level)
Adjusts the volume of the sound that has passed through the
patch multi-effects.
Value: 0–127
PFX Chorus Send Level
9
(Patch Multi-Effects Chorus Send Level)
Adjusts the amount of chorus for the sound that passes through
patch multi-effects. If you don't want to add the Chorus effect,
set it to "0."
Value: 0–127
PFX Reverb Send Level
10
(Patch Multi-Effects Reverb Send Level)
Adjusts the amount of reverb for the sound that passes through
patch multi-effects. If you don't want to add the Reverb effect,
set it to "0."
Value: 0–127
Patch Level
11
Adjusts the volume of the patch.
Value: 0–127
Part Level
12
Adjusts the volume of the part.
Value: 0–127
Part Output Level
13
Sets the level of the signal sent to the output destination chosen
by Part Output Assign.
Value: 0–127
Part Chorus Send Level
14
Sets the level of the signal sent to chorus for each part. If you
don't want to add the Chorus effect, set it to "0."
Value: 0–127
Part Reverb Send Level
15
Sets the level of the signal sent to reverb for each part. If you
don't want to add the Reverb effect, set it to "0."
Value: 0–127