V-Link Parameters; Resetting The Image - Roland Fantom G8 User Manual

About V-LINK

V-LINK Parameters

Note Tx Ch
MIDI channel that will switch clips/palettes and will control
dissolve time.
Value: 1–16
Clip 1 Note No.
Pads 1–16 correspond to clips (or palettes). We recommend that you
press [PAD SETTING] to access the Pad setting screen, and set to
"Note," using Quick Setup (p. 192) and set Clip1 Note No. to the
same value as the "Pad Base Note" setting.
Value: 0(C-1)-127(G9)
Dissolve Time
Control change number that controls the dissolve time (time over
which the image switches)
Value: OFF, CC1, CC5, CC7, CC10, CC11, CC71-74, CC91-
93, Channel Aftertouch
Ctrl Tx Ch
MIDI channel that will control the color Cb/Cr, brightness, and
video effect switching
Value: 1-16
Play Speed Ctrl
Range of video playback speed
The three values are the playback speeds (multiples of normal
speed) at the left, center, and right positions of the pitch bend.
Value: 0.0-1.0-2.0, 0.5-1.0-2.0, 0.0-1.0-4.0, 0.5-1.0-4.0, 0.0-1.0-
8.0, 0.5-1.0-8.0, 0.0-1.0-16.0, 0.5-1.0-16.0, 0.0-1.0-32.0,
0.5-1.0-32.0,0.0-2.0-4.0, 0.0-4.0-8.0, 0.0-8.0-16.0, 0.0-
16.0-32.0, -2.0-1.0-4.0, -6.0-1.0-8.0
Color Cb Ctrl
Control change number that controls the Cb color of the image
Color Cr Ctrl
Control change number that controls the Cr color of the image
Brightness Ctrl
Control change number that controls the brightness of the image
VFX1–4 Ctrl
Control change number that controls the video effect
Fade Ctrl
Control change number that controls the output fade
Value: OFF, CC1, CC5, CC7,CC10, CC11, CC71-74, CC91-
93, Channel Aftertouch
306
PAD MODE
Selects whether the pads will switch clips or palettes.
Value: CLIP, PALETT
Press [F1 (Clip)]: switches clips
Press [F2 (Palett)]: switches palettes
Local Sw
Specifies whether the internal sound generator is disconnected (OFF)
from the pads, or not (OFF).
Procedure: Press [F5 (Local Sw)].
Value: OFF, ON
Clip Filter
(check boxes 1-32)
Clips that are checked can be switched. Enable/disable switching for
each clip
Value: OFF, ON
Using the Clip Filter
For example, suppose that of the rhythm set you input in the
part used for V-LINK (i.e., the part of the same number as the
Note Tx Channel), you want only the kick and snare to switch
clips. In this case, check only the clips that correspond to the
note numbers of the kick and snare. The clips will switch when
the kick or snare plays.

Resetting the Image

Clip Reset
Turn off the image (solid black).
Procedure: Press [F3 (Clip Reset)].
All Reset
The effect applied to the image will be reset, and brightness, color
difference, etc. will all return to the default value.
Procedure: Press [F4 (All Reset)].