Kyocera KM-8530 User Manual page 579

UNIX Printing through TCP/IP (Continued)
Setting Up a SCO UNIX Remote Printer to Use lpd
Use the following procedure to set up a remote printer on the host that sends jobs to the network inter-
face card using lpd.
1.
At the prompt, enter the mkdev rlp command.
You cannot run mkdev rlp twice. If you have additional printers to be configured, use the rlp-
conf command.
2.
You are now asked a series of questions. Respond as follows (shown
in bold type):
Please enter a printer name: lprprinter1
Is lprprinter1 a remote printer or a local printer? R
Enter remote host name: lprprinter
Confirm the information you entered: Y
Confirm the preceding connection as your system
default: Y
Enter another printer name or quit setup: Q
3.
If necessary, stop and restart your remote daemon.
4.
Using a line editor of your choice, edit the /etc/printcap file and change
the:
rp=entry to PORT1.
Chapter 24 UNIX Configuration
579