Default Gateway - Kyocera KM-8530 User Manual

Kyocera km-8530: users manual

Hide thumbs Also See for KM-8530:

Table of Contents

Setups on the Control Panel (Continued)

Default Gateway

Lets you enter the IP address of the default gateway. This IP address is made up of four sets of numbers

(each from 0 to 255), separated by dots, (e.g, [192.168.0.1]).

Base Port Number

Lets you enter a base port number from 1000 to 65530.

The default is [10000].

Lets you set whether DHCP (Dynamic Host Configuration Protocol) is enabled or not. The default is

[DHCP Enable].

If you selected [DHCP Disable], make sure to select [YES] for [Enable IP address defined], and

specify a valid IP address to [IP Address].

Chapter 19 Copier Setup

Table of Contents