Kyocera KM-8530 User Manual page 195

To output offset copies (Continued)
●
Operating procedures of
Limitation
[Offset] cannot be set in the following cases:
• When [DF-630 Finisher] or [DF-635 Finisher] is not available in [Setup] tab
• When [Sub tray] is selected in [Paper] tab - [Output Tray]
• When [Fold only], [Fold, Trim], [Fold, Stitch] or [Fold, Stitch, Trim] is selected in [Paper] tab -
[Features] field
If you attempt to make a setting corresponding to the incongruous combinations described that cannot be set on
the printer driver, a message will be displayed. Check the details of the message and adjust the relationship with
other settings.
1.
Open [Paper] tab of [Properties] window.
When displayed from an application with Windows 98.
2.
Select the [Offset] in the [Features] field.
3.
Select the [On] in the pull-down menu under it.
The default is [OFF].
4.
Click the [OK] button to close the [Properties] window.
PCL5e
195
Chapter 5 Printing from Windows