Ip Snooping Vlan Last-Member-Interval - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.13.8 ip snooping vlan last-member-interval

Function
Sets the monitoring time (in seconds) to check for leaving of the last member of IP multicast group. If an IGMP Report
message is not issued within the monitoring time after reception of IGMP Leave message, the IP multicast group is deleted.
Use the no form to return to the default setup.
Prompt
xg(config)#
Command syntax
ip snooping vlan <1-4094> last-member-interval <1-9>
no ip snooping vlan <1-4094> last-member-interval
Parameter
vlan <1-4094>
Specifies a VLAN to change its settings.
last-member-interval <1-9>
Specifies the monitoring time (in seconds) to check for member leaving.
Command type
Configuration command
Default
2 seconds
Message
% Global IGMP snooping is not enabled.
Explanation
The global IGMP snooping of the XG1200 is disabled.
Solution
Enable the global IGMP snooping using the "ip snooping protocol" command first, then reissue the "ip snooping
vlan last-member-interval" command.
% Vlan id is not found. vid=%1$
Explanation
The specified VLAN has not been created.
[[Inserted string]]%1$: Specified VID
Solution
Create a VLAN using the "vlan" command first, then reissue the "ip snooping vlan" command.
% IGMP snooping vlan-%1$ is not enabled.
Explanation
IGMP snooping of the specified VLAN is disabled.
[[Inserted string]]%1$: Specified VID
Solution
Enable the IGMP snooping of the VLAN using the "ip snooping vlan" command first, then reissue the "ip snooping
vlan last-member-interval" command.
Example
Set the monitoring time to check for leaving of VLAN 2 to 3 seconds.
xg(config)# ip snooping vlan 2 last-member-interval 3
154/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005