Selecting the Active Port
Each server port is assigned a port ID (see "Port ID Numbering" on page 12). Any server can be
directly accessed with a Hotkey combination that specifies the port ID that the server is connected to. To
select the active port:
1. Invoke Hotkey mode:
2. Enter the port ID. The port ID numbers display on the command line as you enter them. Use
[
B
ACKSPACE
3. Press [
Hotkey mode.
Note: In Hotkey mode, the KVM focus will not switch to a port if an invalid switch or port
number is entered. The Hotkey command line will continue to display until a valid switch and
port number combination is entered, or Hotkey mode is exited.
Auto Scan Mode Switching
Auto Scan automatically switches at regular intervals through all the active computer ports accessible to
the currently logged on user. This allows activity to be monitored automatically. See "F7: SCAN" on
page 22 for more information.
Setting the scan interval
The amount of time Auto Scan stays focused on each port is set with the "Scan Duration" setting of the
OSD F3: SET function (see "F3: SET" on page 17). The scan interval can be changed before
activating Hotkey Auto Scanning by entering the following Hotkey combination:
1. Invoke Hotkey mode: [
2. Enter
of the focus time in seconds.
3. Press [
Invoking Auto Scan
To invoke Auto Scanning mode, enter the following Hotkey combination:
1. Invoke Hotkey mode: [
2. Press
Exiting Auto Scan
To exit Auto Scan press [
24
[N
L
UM
OCK
to erase any mistakes.
]
] to focus the KVM switches to the designated computer and automatically exits
E
NTER
N
L
UM
OCK
: Where [A] is the letter A, and [N] is a number from 1-255 that represents the length
[A][
]
N
] to exit Hotkey mode. Auto Scanning can now be started.
E
NTER
N
L
UM
OCK
+ [
]: To start Auto Scanning mood.
[A]
E
NTER
] or [
E
S
SC
PACEBAR
.
] + [-]
[C
] + [F12]
OR
TRL
] + [-] or [
] + [
].
C
F12
TRL
] + [-] or [
] + [
].
C
F12
TRL
]. Scanning stops when Auto Scan is exited.