Shutdown (Administrator Exec Mode) - Fujitsu XG1200 User Manual

XG1200 User's Guide
User Vlan Protocol ID
User defined VLAN protocol identifier (User VLAN Protocol ID) is displayedin a hexadecimal starting with 0x.
Filter Information
Ingress Filter(no vlan member)
The state of ingress filtering by VLAN ID is displayed.
−
−
Ingress Filter(tagged frame)
The state of ingress filtering of a tagged frame is displayed.
−
−
Ingress Filter(untagged frame)
The state of ingress filtering of an untagged frame is displayed.
−
−
Example
Display the state of the switch port 3.
xg> show interface port 3

5.8.2 shutdown (Administrator exec mode)

Function
Shuts down the port of a switch from the administrator exec mode, and stops the optical signal of XENPAK
Use the no form to enable the port of the switch again.
Prompt
xg#
Command syntax
shutdown port <1-12> [ <1-12> ]
no shutdown port <1-12> [ <1-12>
Parameter
port <1-12> [ <1-12> ]
Specifies the port number to shut down or enable.
When specifying multiple port numbers, list them separated with " " (space).
Command type
Operation management commands (for XENPAK maintenance)
Example
Shut down switch ports 3 and 4. Then, make them usable again.
xg# shutdown port 3 4
xg# no shutdown port 3 4
Disabled
The ingress filtering by VLAN ID is disabled.
Enabled
The ingress filtering by VLAN ID is enabled.
Discards frames of VLAN ID not belonging to VLAN member, when they are received.
Disabled
The ingress filtering of a tagged frame is disabled.
Enabled
The ingress filtering of a tagged frame is enabled.
Discards tagged frames when they are received.
Disabled
The ingress filtering of an untagged frame is disabled.
Enabled
The ingress filtering of a tagged frame is enabled.
Discards untagged frames when they are received.
All Rights Reserved, Copyright (C) PFU LIMITED 2005
]
107/258