Boot-System - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.18.9 boot-system

Function
Switches the firmware to be used for the next startup of the XG1200.
Use this command only if a problem has occurred when you are using a new firmware.
Prompt
xg#
Command syntax
boot-system { 1 | 2 }
Parameter
{ 1 | 2 }
Specifies a number of the firmware to be used after the next system startup.
The applicable firmware version can be checked by the "show system information" command.
−
−
Command type
Operation management command
Message
% Attempted to change to invalid firmware. Command failed.
Explanation
The previous firmware updating may not be completed normally and you cannot switch the firmware.
Solution
Update the firmware again.
If the error recurs, contact to the maintenance support personnel.
% 1$ in SRAM is invalid.
Explanation
Inconsistency of non-volatile (SRAM) memory data was found due to abended firmware updating or others.
[[Inserted string]]%1$: Abnormal memory contents
Solution
"Restart the system using the "reset" command. Then, retry firmware updating.
If the error recurs, contact to the maintenance support personnel.
Example
Change the firmware to be used for the next system startup using the "boot-system" command.
Then, make sure that the firmware information (Next Startup Firmware) to be used for the next system startup has been
changed using the "show system information" command.
xg# boot-system 1
xg# show system information
Firmware Information
1
Uses firmware 1 for the next system startup.
2
Uses firmware 2 for the next system startup.
Firmware[1] : E10L05 XF0022 2005/08/23-18:42:52
Updated Time : 2005/08/21-22:08:12
Firmware[2] : E10L06 XF0012 2005/08/31-19:27:12
Updated Time : 2005/08/23-10:57:53
Current Firmware
Next Startup Firmware : [1]
All Rights Reserved, Copyright (C) PFU LIMITED 2005
: [2]
205/258