Table of Contents
Advertisement
XG1200 User's Guide
5.15.2 snmp-server location
Function
Sets the installation location of the XG1200.
Use the no form to return to the default setup.
Prompt
xg(config)#
Command syntax
snmp-server location SYSTEM-LOCATION
no snmp-server location
Parameter
SYSTEM-LOCATION
Specifies the installation location of the XG1200. The location name can be up to 255 alphanumeric characters.
Command type
Configuration command
Default
None
Message
% SYSTEM-LOCATION is too long.
Explanation
The location name specified by SYSTEM-LOCATION has exceeded the limit length.
Solution
Review the length of system location name and reissue the command.
% SYSTEM-LOCATION cannot be used.
Explanation
An illegal character has been used in the SYSTEM-LOCATION name.
Solution
Review the system location name setting and reissue the command.
Example
Specify the system installation location as "3F West":
xg(config)# snmp-server location 3F West
183/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005
Advertisement
Table of Contents
