About Command Reference; Command System - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.1 About Command Reference

This section describes how to read command references.

5.1.1 Command System

The following is the system of commands provided in the XG1200:
Management LAN Interface Configuration
commands
Serial/telnet configuration commands
System Basic Operation commands
Configuration Information Operation
commands
Switch Basic Configuration commands
Link Aggregation Configuration commands
Switch Port Configuration commands
Spanning Tree Protocol (STP) Setup
commands
Virtual LAN (VLAN) Configuration commands
Quality of Service (QoS) Setup commands
Port Mirroring Setup commands
IGMP Snooping Setup commands
Statistics commands
SNMP Configuration commands
RMON Configuration commands
System Status Display commands
Maintenance commands
Item
They are used to set items related to management LAN interface.
They are used to set items related to serial and telnet connections.
They are necessary for system operation such as system time setting
and password setting, and file operation.
They are used for operation related to configuration information
(running-config and startup-config) of the XG1200.
They are used to set the basic settings of the XG1200 switches in
general.
They are used to create/delete aggregation groups.
They are used to set items related to operating characteristics of each
switch port.
They are used to set items related to STP (Spanning Tree Protocol).
They are used to set items related to virtual LAN (VLAN).
They are used to set QoS (Quality of Service) configuration.
They are used to set port mirroring.
They are used to set items related to IGMP Snooping.
They are used to display various statistics.
They are used to set items related to SNMP.
They are used to set items related to RMON.
They are used to display the system status of the XG1200 or
operational status of the hardware.
They are necessary for maintenance.
52/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005
Function