Help; Password - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.4.7 help

Function
Displays help on how to use CLI.
Prompt
xg>, xg#, xg(config)# , xg(config-if)# , xg(config-agg)# , xg(config-line)#
Command syntax
help
Command type
Operation management commands

5.4.8 password

Function
Change the login password to the XG1200.
Prompt
xg#
Command syntax
password
Command type
Operation management commands
Default
"password"
Message
Bad password: too short.
Explanation
The password is too short.
Solution
Specify the password using five or more characters.
Bad password: too long.
Explanation
The password is too long.
Solution
Specify the password using 16 or less characters.
Note
Specify the password length in the range of 5 to 16 characters.
Make a note of the changed password and retain it. If you forget the password, you cannot login the next time.
Login password information is not included in the configuration information. Therefore, even when the configuration
information is downloaded in another device, the password information will not be reflected.
Example
Change the login password.
xg# password
Changing password for admin
Old password:******
Enter the new password (minimum of 5, maximum of 16 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:******
Re-enter new password: ***** ← Enter the new password again for confirmation.
Password changed.
← Enter the password.
(The entered password is not displayed.)
← Enter the password.
(The entered password is not displayed.)
(The entered password is not displayed.)
66/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005