Set Up Ip Address - Fujitsu XG2600 Hardware Manual

XG2600 Hardware Guide
2.6

Set up IP address

Please set the IP address at times when it is required.
Eg. When setting the switch through www browser or installing a firmware from the initial state of the purchase.
The following commands show how to set up the IP address (ex. 192.168.1.1)
Command (When connecting through management port)
XG2600# configure
XG2600(config)# oob ip address 192.168.1.1/24 3
XG2600(config)# commit
XG2600(config)# exit
XG2600#
Command (When connecting through10GBASE-R (SFP+) port)
XG2600# configure
XG2600(config)# lan 0 ip address 192.168.1.1/24 3
XG2600(config)# lan 0 vlan 1
XG2600(config)# commit
XG2600(config)# exit
XG2600#
Precautions
• The IP address is not set at the initial state of the purchase. Please set the IP address through console.
• When logging in by console, you will not be able to log in from the www browser. Please make sure to log off from
the console after setting up the IP address.
• Please set up different network address when setting "oob ip address" command and "lan ip" address command at
the same time.
56
Chapter 2 Installation

Set up IP address