Notes On Link Aggregation - Fujitsu XG1200 User Manual

XG1200 User's Guide

4.4.4 Notes on Link Aggregation

The port in aggregation group whose number is the smallest serves as a master port.
The setting of an aggregation group immediately after the establishment of link aggregation take over the same settings as
those for the master port, excluding the portion of it. The setting that is not taken over from those for the master port are:
"link-pass-through"
The information registered in MAC address table
"spanning-tree port-path-cost"
When changing the settings for aggregation group that has already been created, the aggregation group changes to a
linkdown state, and then to a linkup state if one of the following conditions satisfied.
A master port has been removed
A master port has been changed
The "protocol" or "lacp-mode" parameter has been changed
Set for the ports to be configured is cleared.
All entries which will become port members that configure aggregation are cleared.
Will be adjusted to match the number of ports that configures aggregation.
All Rights Reserved, Copyright (C) PFU LIMITED 2005
33/258