Port Security Commands; Config Port_Security Ports - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
The port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command

config port_security ports

show port_security
delete port_security_entry
vlan_name
clear port_security_entry
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Parameters
[<portlist> | all ] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
{ports <portlist>}
<vlan_name 32> mac_address <macaddr> port <port>
port <portlist>
NOTE: The uplink module ports (DES-3010F/G ports 9-10, DES-3018 ports
17-18, DES-3026 ports 25-26) do not support the port security function.
Used to configure port security settings.
config port_security ports [<portlist> | all ] {admin_state
[enable | disable] | max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
This command allows for the configuration of the port security
feature. Only the ports listed in the <portlist> are effected.
ports <portlist> − Specifies a port or range of ports to be
configured for port security.
all − Configure port security for all ports on the Switch.
admin_state [enable | disable] – Enable or disable port security for
the listed ports.
max_learning_addr <max_lock_no 0-10> - Use this to limit the
number of MAC addresses dynamically listed in the FDB for the
ports.
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset] – Indicates the method of locking addresses. The
user has three choices:
Permanent – The locked addresses will not age out after
the aging timer expires.
DeleteOnTimeout – The locked addresses will age out
after the aging timer expires.
DeleteOnReset – The locked addresses will not age out
until the Switch has been reset.
P S
ORT ECURITY
105
19
C
OMMANDS