Create Snmp User - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
Command
delete snmp group
show snmp groups
create snmp host
delete snmp host
show snmp host
enable rmon
disable rmon
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
disable snmp traps
enable snmp
authenticate traps
disable snmp
authenticate traps
show snmp traps
config snmp
system_contact
config snmp
system_location
config snmp
system_name
Each command is listed, in detail, in the following sections.

create snmp user

Purpose
Syntax
Description
Parameters
Parameters
<view_name 32> | notify_view <view_name 32>}
<groupname 32>
<ipaddr> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]] <auth_string 32>
<ipaddr>
{<ipaddr>}
<ipaddr>
<ipaddr>
<ipaddr>
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
create snmp user <SNMPname 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32>| sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
The create snmp user command creates a new SNMP user and
adds the user to an SNMP group that is also created by this
command.
<SNMPname 32> − An alphanumeric name of up to 32 characters
that will identify the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters
that will identify the SNMP group the new SNMP user will be
27