Spanning Tree Commands; Config Stp - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
The Switch supports 802.1d STP and 802.1w Rapid STP. The spanning tree commands in the Command Line Interface (CLI)
are listed (along with the appropriate parameters) in the following table.
Command

config stp

config stp ports
enable stp
disable stp
show stp
show stp ports
Each command is listed, in detail, in the following sections.
config stp
Purpose
Syntax
Description
Parameters
Parameters
{maxage <value 6-40> | hellotime <value 1-10> | forwarddelay
<value 4-30> | priority <value 0-61440> | version [rstp | stp] |
txholdcount <value 1-10> | fdpdu [enabled | disabled]
<portlist> {cost [auto | <value 1-200000000>] | priority <value 0-
240> | migrate [yes | no] | edge [true | false] | p2p [true | false |
auto] | state [enabled | disabled]}
{<portlist>}
Used to setup STP and RSTP on the Switch.
config stp {maxage <value 6-40> | hellotime <value 1-10> |
forwarddelay <value 4-30> | priority <value 0-61440> | version
[rstp | stp] | txholdcount <value 1-10> | fdpdu [enabled |
disabled]
This command is used to setup the Spanning Tree Protocol (STP)
for the entire switch.
maxage <value 6-40> − The maximum amount of time (in seconds)
that the Switch will wait to receive a BPDU packet before
reconfiguring STP. The default is 20 seconds.
hellotime <value 1-10> − The time interval between transmission of
configuration messages by the root device. The default is 2 seconds.
forwarddelay <value 4-30> − The maximum amount of time (in
seconds) that the root device will wait before changing states. The
default is 15 seconds.
priority <value 0-61440> − A numerical value between 0 and 61440
that is used in determining the root device, root port, and designated
port. The device with the highest priority becomes the root device.
The lower the numerical value, the higher the priority. The default is
32,768.
version [rstp | stp] - Select the Spanning Tree Protocol version used
for the Switch. For IEEE 802.1d STP select stp. Select rstp for IEEE
802.1w Rapid STP.
txholdcount <value 1-10> - The maximum number of Hello packets
transmitted per interval. Default value = 3.
61
S T
PANNING
9
C
REE OMMANDS