Config 802.1X Auth_Mode; Show 802.1X Auth_State; To Configure 802.1X Authentication By Mac Address - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

config 802.1x auth_mode

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure 802.1x authentication by MAC address:

DES-3026:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3026:4#

show 802.1x auth_state

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the 802.1x authentication states (stacking disabled) for Port-based 802.1x:
Used to configure the 802.1x authentication mode on the Switch.
config 802.1x auth_mode {port_based | mac_based]
The config 802.1x authentication mode command is used to enable
either the port-based or MAC-based 802.1x authentication feature
on the Switch.
[port_based | mac_based ports] − The Switch may authenticate
802.1x by either port or MAC address.
Only administrator-level users can issue this command.
Used to display the current authentication state of the 802.1x server on the
Switch.
show 802.1x auth_state {ports <portlist>}
The show 802.1x auth_state is used to display the current 802.1x
authentication state of the specified ports of the Port-based or MAC-based
Network Access Control server application on the Switch.
The following details what is displayed:
Port number − Shows the physical port number on the Switch, in port-based
mode only.
MAC Address – Displays the MAC address of the Switch in MAC-based
mode only.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating /
Authenticated / Held / ForceAuth / ForceUnauth − Shows the current state of
the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success /
Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was authenticated,
and can access the network. Unauthorized means that the user was not
authenticated, and cannot access the network.
ports <portlist> − Specifies a port or range of ports to be viewed.
Only administrator-level users can issue this command.
110