DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
DES-3026:4#show serial_port
Command: show serial_port
DES-3026:4#
config serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the baud rate:
enable clipaging
Baud Rate
: 9600
Data Bits
: 8
Parity Bits
: None
Stop Bits
: 1
Auto-Logout
: 10 mins
Used to configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
This command is used to configure the serial port's baud rate and auto
logout settings.
baud rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that will be
used to communicate with the management host.
auto_logout - This parameter will allow the user to choose the time the
Switch's serial port will be idle before automatically logging out. The user
may choose one of the following.
never − No time limit on the length of time the console can be open
with no user input.
2_minutes − The console will log out the current user if there is no
user input for 2 minutes.
5_minutes − The console will log out the current user if there is no
user input for 5 minutes.
10_minutes − The console will log out the current user if there is
no user input for 10 minutes.
15_minutes − The console will log out the current user if there is
no user input for 15 minutes.
Only administrator-level users can issue this command.
DES-3026:4#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DES-3026:4#
16