Show Syslog; Create Syslog Host; To Display The Current Status Of The Syslog Function - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

show syslog

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To display the current status of the syslog function:

create syslog host

Purpose
Syntax
Description
Parameters
DES-3026:4#disable syslog
Command: disable syslog
Success.
DES-3026:4#
Used to display the syslog protocol status as enabled or disabled.
show syslog
The show syslog command displays the syslog status as enabled
or disabled.
None.
None.
DES-3026:4#show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3026:4#
Used to create a new syslog host.
create syslog host <index 1-4> {severity [informational |
warning | all] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <int> | ipaddress <ipaddr>
state [enable | disable]}
The create syslog host command is used to create a new syslog
host.
<index 1-4> − Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is currently
supported on the Switch.
Numerical
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
Severity
54