Create Snmp Host; To Create An Snmp Host To Receive Snmp Messages - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

create snmp host

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To create an SNMP host to receive SNMP messages:

DES-3026:4#create snmp host 10.48.74.100 v3 auth_priv public
Command: create snmp host 10.48.74.100 v3 auth_priv public
Success.
DES-3026:4#
Used to create a recipient of SNMP traps generated by the Switch's
SNMP agent.
create snmp host <ipaddr> [v1 | v2c | v3 [noauth_nopriv |
auth_nopriv | auth_priv] <auth_string 32>]
The create snmp host command creates a recipient of SNMP traps
generated by the Switch's SNMP agent.
<ipaddr> − The IP address of the remote management station that
will serve as the SNMP host for the Switch.
v1 – Specifies that SNMP version 1 will be used. The Simple
Network Management Protocol (SNMP), version 1, is a network
management protocol that provides a means to monitor and control
network devices.
v2c – Specifies that SNMP version 2c will be used. The SNMP v2c
supports both centralized and distributed network management
strategies. It includes improvements in the Structure of Management
Information (SMI) and adds some security features.
v3 – Specifies that the SNMP version 3 will be used. SNMP v3
provides secure access to devices through a combination of
authentication and encrypting packets over the network. SNMP v3
adds:
Message integrity − ensures that packets have not been
tampered with during transit.
Authentication − determines if an SNMP message is from a
valid source.
Encryption − scrambles the contents of messages to prevent
it being viewed by an unauthorized source.
noauth_nopriv − Specifies that there will be no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_nopriv − Specifies that authorization will be required, but there
will be no encryption of packets sent between the Switch and a
remote SNMP manager.
auth_priv − Specifies that authorization will be required, and that
packets sent between the Switch and a remote SNMP manger will
be encrypted.
−
<auth_sting 32> An alphanumeric string used to authorize a
remote SNMP manager to access the Switch's SNMP agent.
Only administrator-level users can issue this command.
39