Disable Telnet; Enable Web - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
enable telnet
Description
Parameters
Restrictions
Example usage:
To enable Telnet and configure port number:
DES-3026:4#enable telnet 23
Command: enable telnet 23
Success.
DES-3026:4#

disable telnet

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Telnet protocol on the Switch:

enable web

Purpose
Syntax
Description
Parameters
This command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP or UDP port number the Switch will
use to listen for Telnet requests.
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The "well-known" TCP port
for the Telnet protocol is 23.
Only administrator-level users can issue this command.
Used to disable the Telnet protocol on the Switch.
disable telnet
This command is used to disable the Telnet protocol on the Switch.
None.
Only administrator-level users can issue this command.
DES-3026:4#disable telnet
Command: disable telnet
Success.
DES-3026:4#
Used to enable the HTTP-based management software on the
Switch.
enable web <tcp_port_number 1-65535>
This command is used to enable the Web-based management
software on the Switch. The user can specify the TCP port number
the Switch will use to listen for Telnet requests.
<tcp_port_number 1-65535> − The TCP port number. TCP ports
b d b
18
1 d 6 3 Th " ll k " f h