To Display Bandwidth Control Settings - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
show bandwidth_control
Syntax
Description
Parameters
Restrictions
Example usage:

To display bandwidth control settings:

DES-3026:4#show bandwidth_control 1-12
Command: show bandwidth_control 1-12
Bandwidth Control Table
Port
----
1
2
3
4
5
6
7
8
9
10
11
12
DES-3026:4#
show bandwidth_control {<portlist>}
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
<portlist> − Specifies a port or range of ports to be viewed.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
None.
RX Rate (kbit/sec) TX_RATE (kbit/sec)
------------------------ ----------------------
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
100000 100000
no_limit no_limit
no_limit no_limit
83