Basic Switch Commands; Create Account - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command

create account

config account
show account
show session
show switch
show config
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
save
reboot
reset
login
logout
ping
Each command is listed, in detail, in the following sections.
create account
Purpose
Syntax
Description
Parameters
Restrictions
Parameters
[admin | user] <username 15>
<username>
[dram | flash]
{baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never |
2_minutes | 5_minutes| 10_minutes | 15_minutes]}
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
{[config | system]}
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
Used to create user accounts.
create [admin | user] <username 15>
The create account command is used to create user accounts that
consist of a username of 1 to 15 characters and a password of 0 to
15 characters. Up to 8 user accounts can be created.
admin <username>
user <username>
Only Administrator-level users can issue this command.
11
B S
ASIC WITCH
4
C
OMMANDS