Config Sim; To Change The Time Interval Of The Discovery Protocol; To Change The Hold Time Of The Discovery Protocol - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

config sim

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To change the time interval of the discovery protocol:

DES-3026:4#config sim candidate dp_interval 30
Command:config sim candidate dp_interval 30
Success.
DES-3026:4#

To change the hold time of the discovery protocol:

DES-3026:4#config sim candidate hold_time 120
Command: config sim candidate hold_time 120
Success.
DES-3026:4#
Used to configure role parameters for the SIM protocol on the
Switch.
config sim [candidate] | dp_interval <30-90> | hold_time <sec
100-255>]
This command is used to configure parameters of switches of the
SIM.
candidate – Used to change the role of a commander switch to a
candidate switch.
dp_interval <30-90> – The user may set the discovery protocol
interval, in seconds that the Switch will send out discovery packets.
Returning information to the commander switch will include
information about other switches connected to it. (Ex. MS, CaS).
The user may set the discovery protocol interval from 30 to 90
seconds.
hold time <sec 100-255> – Using this parameter, the user may set
the time, in seconds, the Switch will hold information sent to it from
other switches, utilizing the discovery interval protocol. The user
may set the hold time from 100 to 255 seconds.
Only administrator-level users can issue this command.
139