Igmp Snooping Commands; Config Igmp_Snooping - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command

config igmp_snooping

config igmp_snooping
querier
config router_ports
enable igmp snooping
disable igmp snooping
show igmp snooping
show igmp snooping group
show router_ports
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
Parameters
[<vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable] | fast_leave [enable |
disable]}
[<vlan_name 32> | all] { query_interval <sec 1-65535>|
max_response_time <sec 1-25> robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enabled |
disabled]
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} {static | dynamic}
Used to configure IGMP snooping on the Switch.
config igmp_snooping [<vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 0-
16711450> | state [enable | disable] | fast_leave [enable | disable]}
This command allows the user to configure IGMP snooping on the Switch.
<vlan_name 32> − The name of the VLAN for which IGMP snooping is to
be configured.
all – Selecting this parameter will configure IGMP for all VLANs on the
Switch.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a
host can be a member of a multicast group without the Switch receiving a
host membership report. The default is 260 seconds.
router_timeout <sec 0-16711450> − Specifies the maximum amount of time
a route can be a member of a multicast group without the Switch receiving
a host membership report. The default is 260 seconds.
leave_timer <sec 0-16711450> − Leave timer. The default is 2 seconds.
state [enable | disable] − Allows the user to enable or disable IGMP
snooping for the specified VLAN.
fast_leave [enable | disable] – This parameter allows the user to enable the
fast leave function. Enabled, this function will allow members of a multicast
IGMP S
NOOPING
99
18
C
OMMANDS