Config 802.1P User_Priority; To Configure 802.1 User Priority On The Switch - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

config 802.1p user_priority

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure 802.1 user priority on the Switch:

DES-3026:4# show scheduling
Command: show scheduling
QOS Output Scheduling
Class ID Weight
--------------- -------------
Class-0 1
Class-1 2
Class-2 4
Class-3 15
DES-3026:4#
Used to map the 802.1p user priority of an incoming packet to one of
the four hardware classes of service available on the Switch.
config 802.1p user_priority <priority 0-7> <class_id 0-3>
The config 802.1p user_priority command is used to configure the
way the Switch will map an incoming packet, based on its 802.1p
user priority tag, to one of the four hardware priority classes of
service available on the Switch. The Switch's default is to map the
incoming 802.1p priority values to the four hardware classes of
service according to the following chart:
802.1p Switch Priority
Value Queue
--------- ------------------
0
1
2
3
4
5
6
7
<priority 0-7> − Specifies which of the eight 802.1p priority values (0
through 7) you want to map to one of the Switch's hardware priority
classes of service (<class_id>, 0 through 3).
<class_id 0-3> − Specifies which of the Switch's hardware priority
classes of service the 802.1p priority value (specified above) will be
mapped to.
Only administrator-level users can issue this command.
0
0
1
1
2
2
3
3
78