Link Aggregation Commands; Create Link_Aggregation - D-Link DES-3010F Command Line Interface Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command

create link_aggregation

delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
DES-30XX Layer 2 Switch CLI Reference Manual
Parameters
group_id <value 1-3> {type [lacp | static]}
group_id <value 1-3>
group_id <value 1-3> {master_port <port> | ports <portlist> | state
[enable | disable]}
[mac_source | mac_destination | mac_source_dest]
{group_id <value 1-3> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-3> {type [lacp | static]}
This command will create a link aggregation group with a unique identifier.
<value 1-3> − Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
type – Specify the type of link aggregation used for the group. If the type is
not specified the default type is static.
lacp – This designates the port group as LACP compliant. LACP
allows dynamic adjustment to the aggregated port group. LACP
compliant ports may be further configured (see config lacp_ports).
LACP compliant must be connected to LACP compliant devices.
static – This designates the aggregated port group as static. Static
port groups can not be changed as easily as LACP compliant port
groups since both linked devices must be manually configured if the
configuration of the trunked group is changed. If static link aggregation
is used, be sure that both ends of the connection are properly
configured and that all ports have the same speed/duplex settings.
Only administrator-level users can issue this command.
L A
INK GGREGATION
99
17
C
OMMANDS