Switch Port Commands - D-Link DES-3010F Command Line Interface Reference Manual

The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
config ports
Purpose
Syntax
Description
Parameters
DES-30XX Layer 2 Switch CLI Reference Manual
Parameters
config ports [<portlist> | all] {speed [auto | 10_half | 10_full |
100_half | 100_full | {1000_full {[master | slave]}}] | flow_control
[enable | disable] | state [enable | disable] | description [<desc 1-
32> | clear_description]}
{<portlist>} {[description | err_disabled]}
Used to configure the Switch's Ethernet port settings.
config ports [<portlist> | all] {speed [auto | 10_half | 10_full | 100_half
| 100_full | {1000_full {[master | slave]}}] | flow_control [enable |
disable] | state [enable | disable] | description [<desc 1-32> |
clear_description]}
This command allows for the configuration of the Switch's Ethernet ports.
Only the ports listed in the <portlist> will be affected.
<portlist> − Specifies a port or range of ports to be configured.
all − Configure all ports on the Switch.
speed – Allows the user to set the speed of a port or range of ports, with
the addition of one of the following:
auto − Enables auto-negotiation for the specified range of ports.
[10 | 100 | 1000] − Configures the speed in Mbps for the specified
range of ports. Gigabit ports are statically set to 1000 and cannot be
set to slower speeds.
[half | full] − Configures the specified range of ports as either full-
or half-duplex.
[master | slave] – The master and slave parameters refer to connections
running a 1000BASE-T cable for connection between the Switch port and
other device capable of a gigabit connection. The master setting will allow
the port to advertise capabilities related to duplex, speed and physical
layer type. The master setting will also determine the master and slave
relationship between the two connected physical layers. This relationship
is necessary for establishing the timing control between the two physical
layers. The timing control is set on a master physical layer by a local
source. The slave setting uses loop timing, where the timing comes form
a data stream received from the master. If one connection is set for 1000
master, the other side of the connection must be set for 1000 slave. Any
other configuration will result in a link down status for both ports.
flow_control [enable | disable] – Enable or disable flow control for the
specified ports.
S
WITCH
22
5
P C
ORT OMMANDS