D-Link DES-3010F Command Line Interface Reference Manual page 135

show 802.1x auth_configuration
Parameters
Restrictions
Example usage:
To display the 802.1x configurations:
DES-30XX Layer 2 Switch CLI Reference Manual
and can access the network. Unauthorized means that the user was not
authenticated, and can not access the network.
PAE State: Initialize/Disconnected/Connecting/
Authenticating/Authenticated/Held /ForceAuth/ForceUnauth − Shows the
current state of the Authenticator PAE.
Backend State: Request/Response/Fail/Idle/Initialize − Shows the current
state of the Backend Authenticator.
AdminCtlDir: Both/In − Shows whether a controlled Port that is unauthorized
will exert control over communication in both receiving and transmitting
directions, or just the receiving direction.
OpenCtlDir: Both/In − Shows whether a controlled Port that is unauthorized
will exert control over communication in both receiving and transmitting
directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto − Shows the administrative
control over the port's authorization status. ForceAuth forces the
Authenticator of the port to become Authorized. ForceUnauth forces the
port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure and
the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant (user)
to send EAP Request/Identity packets.
SuppTimeout − Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request/Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a
RADIUS server.
MaxReq − Shows the maximum number of times to retry sending packets to
the supplicant.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled/Disabled − Shows whether or not to re-
authenticate.
ports <portlist> − Specifies a port or range of ports to be viewed.
Only administrator-level users can issue this command.
131