D-Link DES-3010F Command Line Interface Reference Manual page 124

config cpu access_profile
Restrictions
Example usage:
To configure cpu access list entry:
DES-3026:4#config cpu access_profile profile_id 1 add access_id 1 ip vlan default source_ip
20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp type 11 code 32 port 1 deny
Command: config cpu access_profile profile_id 1 add access_id 1 ip vlan default source_ip
20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp type 11 code 32 port 1 deny
Success.
DES-3026:4#
DES-30XX Layer 2 Switch CLI Reference Manual
packet_content_mask – Specifies that the Switch will mask the packet
•
header beginning with the offset value specified as follows:
offset_0-15 - Enter a value in hex form to mask the packet from
•
byte 0 to byte 15.
offset_16-31 - Enter a value in hex form to mask the packet from
•
byte 16 to byte 31.
offset_32-47 - Enter a value in hex form to mask the packet from
•
byte 32 to byte 47.
offset_48-63 - Enter a value in hex form to mask the packet from
•
byte 48 to byte 63.
offset_64-79 - Enter a value in hex form to mask the packet from
•
byte 64 to byte 79.
port <portlist> - The access profile for the CPU may be defined for each
port on the Switch. The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
permit | deny – Specify that the packet matching the criteria configured with
command will either be permitted entry to the CPU or denied entry to the
CPU.
delete access_id <value 1-5> - Use this to remove a previously created
access rule in a profile ID.
Only administrator-level users can issue this command.
120