Disable Autoconfig; Show Autoconfig; To Stop The Autoconfiguration Function; To Show The Autoconfig Configuration Set On The Switch - D-Link DES-3010F Command Line Interface Reference Manual

disable autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To stop the autoconfiguration function:

DES-3026:4#disable autoconfig
Command: disable autoconfig
Success.
DES-3026:4#

show autoconfig

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To show the autoconfig configuration set on the Switch:

DES-30XX Layer 2 Switch CLI Reference Manual
Use this to deactivate autoconfiguration from DHCP.
disable autoconfig
This instructs the Switch not to accept autoconfiguration instruction from
the DHCP server. This does not change the IP settings of the Switch. The
ipif settings will continue as DHCP client until changed with the config ipif
command.
None.
Only administrator-level users can issue this command.
With autoconfig enabled, the Switch ipif settings now define the
NOTE:
Switch as a DHCP client. Use the show switch command to display the
new IP settings status.
Used to display the current autoconfig status of the Switch.
show autoconfig
This will list the current status of the autoconfiguration function.
None.
Only administrator-level users can issue this command.
DES-3026:4#show autoconfig
Command: show autoconfig
Autoconfig disabled.
DES-3026:4#
56