D-Link DES-3010F Command Line Interface Reference Manual page 27

config ports
Restrictions
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex and state enabled:
DES-3026:4#config ports 1-3 speed 10_full state enable
Command: config ports 1-3 speed 10_full state enable
Success.
DES-3026:4#
show ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the configuration of ports 1-5 on the Switch:
DES-3026:4#show ports 1-5
Command: show ports 1-5
Port Port
---
1
2
3
4
5
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
DES-30XX Layer 2 Switch CLI Reference Manual
state [enable | disable] − Enables or disables the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32
characters to describe a selected port interface.
clear_description – Enter this command to clear the port description of the
selected port(s).
Only administrator-level users can issue this command.
Used to display the current configuration of a range of ports.
show ports {<portlist>} {[description | err_disabled]}
This command is used to display the current configuration of a range
of ports.
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the command will allow the
user to view previously configured descriptions set on various ports
on the Switch.
err_disabled – Used to view information about ports that have had
their connection status disabled, for reasons such as STP loopback
detection or link down status.
None.
Settings
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
-------- ---------------------
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Enabled Auto/Enabled
Connection
---------------------
100/Full/none
Link Down
Link Down
Link Down
Link Down
23
Address
--------
Enabled
Enabled
Enabled
Enabled
Enabled