D-Link DES-3010F Command Line Interface Reference Manual page 152

config dst
Restrictions
Example usage:
To configure daylight savings time on the Switch:
DES-30XX Layer 2 Switch CLI Reference Manual
•
<start_week 1-4,last> - The number of the week during the month
in which DST begins where 1 is the first week, 2 is the second
week and so on, last is the last week of the month.
e_week - Configure the week of the month in which DST ends.
•
<end_week 1-4,last> - The number of the week during the month
in which DST ends where 1 is the first week, 2 is the second week
and so on, last is the last week of the month.
s_wday – Configure the day of the week in which DST begins.
•
<start_weekday sun-sat> - The day of the week in which DST
begins expressed using a three character abbreviation (sun, mon,
tue, wed, thu, fri, sat)
e_wday - Configure the day of the week in which DST ends.
•
<end_weekday sun-sat> - The day of the week in which DST
ends expressed using a three character abbreviation (sun, mon,
tue, wed, thu, fri, sat)
s_mth - Configure the month in which DST begins.
•
<start_mth 1-12> - The month to begin DST expressed as a
number.
e_mth - Configure the month in which DST ends.
•
<end_mth 1-12> - The month to end DST expressed as a
number.
s_time – Configure the time of day to begin DST.
•
<start_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
e_time - Configure the time of day to end DST.
•
<end_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
s_date - Configure the specific date (day of the month) to begin DST.
•
<start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to begin DST.
•
<end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30, 60, 90, 120. The
default value is 60.
Only administrator-level users can issue this command.
148