To Change The Time Interval Of The Discovery Protocol; To Change The Hold Time Of The Discovery Protocol; To Transfer The Commander Switch To Be A Candidate; To Transfer The Switch To Be A Commander - D-Link DES-3010F Command Line Interface Reference Manual

config sim
Restrictions
Example usage:

To change the time interval of the discovery protocol:

DES-3026:4#config sim commander dp_interval 30
Command: config sim commander dp_interval 30
Success.
DES-3026:4#

To change the hold time of the discovery protocol:

DES-3026:4#config sim commander hold_time 120
Command: config sim commander hold_time 120
Success.
DES-3026:4#

To transfer the commander switch to be a candidate:

DES-3026:4#config sim candidate
Command: config sim candidate
Success.
DES-3026:4#

To transfer the Switch to be a commander:

DES-3026:4#config sim commander
Command: config sim commander
Success.
DES-3026:4#
To update the name of a group:
DES-30XX Layer 2 Switch CLI Reference Manual
may set the hold time from 100 to 255 seconds.
candidate – Used to change the role of a commander switch to a
candidate switch.
dp_interval <30-90> – The user may set the discovery protocol
interval, in seconds that the Switch will send out discovery packets.
Returning information to the commander switch will include
information about other switches connected to it. (Ex. MS, CaS).
The user may set the dp_interval from 30 to 90 seconds.
hold time <sec 100-255> – Using this parameter, the user may set
the time, in seconds, the Switch will hold information sent to it from
other switches, utilizing the discovery interval protocol. The user
may set the hold time from 100 to 255 seconds.
Only administrator-level users can issue this command.
162